Vector Coatings Products - VersaFlex FSS 45DC-F

VersaFlex FSS 45DC-F

One Odorless, No VOC's

Two 1:1 Mix Ratio by Volume, Fast Return to Service

Three Installation temperature range from -40°F to 300°F

Waterproofing Membrane
Chemical Plants
Tank Linings
Secondary Containment

VersaFlex FSS 45DC-F is a fast set, rapid curing, 100% solids, flexible, two-component polyurea elastomer spray coating material. VersaFlex FSS 45DC-F is used by itself or in combination with other materials to produce coatings, liners, wearing courses, and resilient surfaces on metal and other substrates.

Its extremely fast gel time makes it suitable for applications down to -40°F, without special conditioning of the component resins and isocyanates. VersaFlex FSS 45DC-F produces an extremely tough film at all thicknesses. Single or multiple pass applications produce films from 10 mils to 1,000 mils without appreciable sag or runs. VersaFlex FSS 45DC-F may be applied in all positions and to any properly prepared substrate.

VersaFlex FSS 45DC-F is inert, it will not hydrolyze, leach, or contaminate other materials, and is bondable and paintable. VersaFlex FSS 45DC-F is relatively moisture and temperature insensitive, allowing application in the most problematic ambient conditions.

Applications & Uses

VersaFlex FSS 45DC-F is a superior concrete and metal coating material designed specifically for industrial applications receiving constant or intermittent attack from contained materials, most corrosive substrates and abrasive action. VersaFlex FSS 45DC-F is flexible, accommodating to movement of the substrate, yet strong enough to remain intact under all conditions except major structural dislocations.

With or without reinforcements, FSS 45DC-F may be used in transitional areas with confidence.VersaFlex FSS 45DC-F may be used in interior or exterior applications.

  • VOC's: Zero
  • Solids Content: 100%
  • Gel Time: 4 - 8 seconds
  • Tack Free: 10-15 seconds
  • Tensile Strength: 2,300 - 2,800 psi
  • Tensile Elongation: 580 - 650%
  • Modulus of Elasticity: 300-600 psi
  • Tear Strength: 360 - 390 lb/in
  • Shore (D) Hardness: 45 D
  • Taber Abrasion: 250 mg