Vector Coatings Products - VersaFlex FSS 45 DC

VersaFlex FSS 45DC-F

One 100% Solids, No VOC's, Odorless, No Toxic Vapors, Tough Elastomeric Membrane

Two Excellent Thermal Stability, Minimal Downtime, Low Permeance Rate

Three Good Resistance to a Wide Range of Chemical Attack, USDA Approved, Operating Temperatures -40°F to 350°F

Industrial Facilities
Parking Garage Decks
Below Grade Waterproofing
Above Grade Dampproofing
Water & Waste Water Treatment
Food Processing Facilities
Pulp & Paper Mills
Bottling & Canning Facilities
Walkways & Balconies
Secondary Containment

VersaFlex FSS 45DC is a fast set, rapid gelling, 100% solids, flexible, two- component polyurea elastomer spray coating material. FSS 45DC is used by itself or in combination with other materials to produce coatings, liners, wearing courses, and resilient surfaces on concrete and other substrates.

FSS 45DC produces an extremely tough film at all thicknesses. FSS 45DC may be applied in all positions and to any properly prepared substrate.

FSS 45DC is inert, it will not hydrolyze, leach, or contaminate other materials, and is bondable and paintable. FSS 45DC is relatively moisture and temperature insensitive, allowing application in the most problematic ambient conditions.

Applications & Uses

VersaFlex FSS 45DC is a superior coating material designed specifically for industrial applications receiving constant or intermittent attack from contained materials, subsurface hydrostatic pressure, most corrosive substances, and abrasive action. FSS 45DC is flexible, accommodating to movement of the substrate, yet strong enough to remain intact under all conditions except major structural dislocations.

With or without reinforcements, FSS 45DC may be used in transitional areas with confidence. FSS 45DC may be used in interior or exterior applications.

  • VOC's: Zero
  • Solids Content: 100%
  • Gel Time: 20-30 seconds
  • Tack Free: 90 seconds
  • Tensile Strength: 1950-2350 psi
  • Tensile Elongation: 450-520%
  • Tear Strength: 430 pli, Die C
  • Shore (D) Hardness: 45 D
  • Taber Abrasion: 180 mg