Vector Coatings Products - VersaFlex VF 330

VersaFlex VF 330

One 100% Solid, No VOC's, 1:1 Mix Ration by Volume

Two Rapid Cure, Fast Return to Service

Three Applied by Plural Component Spray, Odorless, Temperature Range from -20°F to 300°F

Tank Linings

VersaFlex VF 330 is a fast set, rapid curing, 100% solids, flexible, two-component abrasion resistant polyurea elastomer spray coating material. VF 330 may be used by itself or in combination with other materials to produce coatings, liners, wearing courses, resilient surfaces on metal and other substrates. Its extremely fast gel time makes it suitable for applications down to -20oF without special conditioning of the component resins and isocyanates.

VF 330 produces an extremely tough film at all thicknesses. Single or multiple pass applications produce films from 10 mils to 1,000 mils without appreciable sag or runs. VF 330 may be applied in all positions and to any properly prepared substrate. VF 330 is inert, it will not hydrolyze, leach, or contaminate other materials, and is bondable and paintable. VF 330 is relatively moisture and temperature insensitive, allowing application in the most problematic ambient conditions.

Applications & Uses

VersaFlex VF 330 is a superior metal coating material designed specifically for industrial applications receiving constant or intermittent attack from contained materials, most corrosive substances and abrasive action. VF 330 may be used to coat any properly prepared substrate. VF 330 is flexible, accommodating to movement of the substrate, yet strong enough to remain intact under all conditions except major structural dislocations.

With or without reinforcements, VF 330 may be used in transitional areas with confidence.

VF 330 may be used in interior or exterior applications. VF 330 is recommended for repair of other films, may be applied to metal and other substrates, in new construction and in cold weather conditions.

  • VOC's: Zero
  • Solids Content: 100%
  • Gel Time: 10 seconds
  • Tack Free: 15 seconds
  • Tensile Strength: 2,500 - 3,000 psi
  • Tear Strength: 480 pli
  • Shore (D) Hardness: 55 D
  • Taber Abrasion: 125 mg
  • Elongation: 200 - 275%
  • Moisture Vapor Transmission: 0.02 perm