P.O. Box 809, North Bend, WA 98045

VersaFlex VF 330


VersaFlex VF 330

One 100% Solid, No VOC’s, 1:1 Mix Ration by Volume

Two Rapid Cure, Fast Return to Service

Three Applied by Plural Component Spray, Odorless, Temperature Range from -20°F to 300°F

Tank Linings

VersaFlex VF 330 is a fast set, rapid curing, 100% solids, flexible, two-component abrasion resistant polyurea elastomer
spray coating material. VF 330 may be used by itself or in combination with other materials to produce coatings, liners,
wearing courses, resilient surfaces on metal and other substrates. Its extremely fast gel time makes it suitable for
applications down to -20oF without special conditioning of the component resins and isocyanates. VF 330 produces
an extremely tough film at all thicknesses. Single or multiple pass applications produce films from 10 mils to
1,000 mils without appreciable sag or runs. VF 330 may be applied in all positions and to any properly prepared
substrate. VF 330 is inert, it will not hydrolyze, leach, or contaminate other materials, and is bondable and paintable.
VF 330 is relatively moisture and temperature insensitive, allowing application in the most problematic ambient

Applications & Uses

VersaFlex VF 330 is a superior metal coating material designed specifically for industrial applications receiving
constant or intermittent attack from contained materials, most corrosive substances and abrasive action. VF 330
may be used to coat any properly prepared substrate. VF 330 is flexible, accommodating to movement of the
substrate, yet strong enough to remain intact under all conditions except major structural dislocations.

With or without reinforcements, VF 330 may be used in transitional areas with confidence.

VF 330 may be used in interior or exterior applications. VF 330 is recommended for repair of other films, may be
applied to metal and other substrates, in new construction and in cold weather conditions.

VOC’s: Zero
Solids Content: 100%
Gel Time: 10 seconds
Tack Free: 15 seconds
Tensile Strength: 2,500 – 3,000 psi
Tear Strength: 480 pli
Shore (D) Hardness: 55 D
Taber Abrasion: 125 mg
Elongation: 200 – 275%
Moisture Vapor Transmission: 0.02 perm